ZyXEL Communications ES-1528 User Manual page 46

Chapter 4 The Web Configurator
Table 4 Navigation Panel Links (continued)
LINK
Statistics
VLAN
Trunk Groups
Mirror
QoS
Rate
Port Rate
Storm
Control
L2 Address
Management Use this screen to add, delete or look up MAC addresses in the MAC address
Display
Cable Diagnostic Use this screen to perform cable testing on individual ports.
Auto DoS
Auto VoIP
Logging
Settings
RAM Logs
Flash Logs
SNMP
Engine ID
Group
User
Community
Trap Station
RMON-Lite
Dynamic ARP
Settings
46
DESCRIPTION
Use these screen to view system statistics such as the number of packets received
on the switch, collisions and errors and to view statistics for individual ports on the
switch.
Use these screens to create new IEEE 802.1Q VLANs as well as view the status
and edit existing IEEE 802.1Q VLANs on the switch.
Use these screens to create trunk groups and add/remove ports from existing trunk
groups.
Use this screen to copy traffic from one port or ports to another port in order that
you can examine the traffic from the first port without interference.
Use these screens to configure queuing with associated queue weights for the
switch.
Use these screens to specify bandwidth limits and storm control limits for the
switch.
Use this screen to cap the maximum bandwidth allowed from specified source(s) to
specified destination(s).
Use this screen to cap the rate of broadcast, multicast and unknown unicast
packets the switch will allow on individual ports.
Use these screens to view and manage the MAC address table.
table.
Use this screen to view the entries in the MAC address table.
Use these screens to activate security features against Denial of Service (DoS)
attacks.
Use these screens to configure settings that automatically give higher priority to
Voice over Internet Protocol (VoIP) traffic.
Use these screens to configure log settings and view system logs.
Use this screen to configure which events the switch should log.
Use this screen to configure logs which are saved to volatile memory. These logs
are cleared when the switch is rebooted.
Use this screen to configure logs which are saved to non-volatile memory. You can
view these logs even after a switch is rebooted.
Use these screens to configure SNMP management settings.
Use this screen to configure SNMP engine ID.
Use this screen to configure groups with different access rights for SNMP
management.
Use this screen to create users and assign them to pre-defined SNMP groups.
Use this screen to define security parameters for SNMP v1 and SNMP v2c.
Use this screen to configure settings that define when notifications are sent to an
external management station.
Use this screen to configure Remote Network Monitoring Management Information
Base (RMON MIB) settings.
Use these screens to enable and configure ARP table settings.
Use this screen to configure ARP table settings.
ES-1528 User's Guide