Insert With Direct Connection (Z.c. Fireplace); Insert With Face Seal Connection - Travis Industries 1250 Insert Owner's Manual

Insert with Direct
Connection (Z.C.
Fireplace)
NOTE:
NOT ALLOWED IN
CANADA
Direct connections
require installation of an
airtight block-off plate or
damper adapter (see
"Block-off Plate
Installation" on page
11).
Insert with Face
Seal Connection
NOTE:
NOT ALLOWED IN
CANADA
Face seal connections
require installation of the
surround panels and
insulation (see the
"Surround Panel
Installation" on page
31).
© Travis Industries
Stove Installation
NOTE: This installation may be
used with a masonry or zero
clearance fireplace. This
illustration depicts a zero
clearance insert, all requirements
in the section "Zero Clearance
Fireplace Requirements" must be
fulfilled prior to installation.
Combustible Mantle
Surround Panels
See the section
"Insert Placement
Requirements" for
minimum clearances
and hearth required.
NOTE: This installation may be
used with a masonry fireplace
only. The requirements in the
section "Masonry Fireplace
Requirements" must be fulfilled
prior to installation.
Flue
Liner
Combustible Mantle
Surround Panels with
insulation (see "Surround
Panels" installation
instructions in the back of
the manual)
See the section "Insert
Placement Requirements"
for minimum clearances
and hearth required.
(for qualified installers only)
Optional
Telescoping Legs
100-01233_000
Stainless steel
chimney connector
must Extend 1' past
the block-off plate.
Damper must
be removed
Block-off plate or
damper adapter
Z.C. (Metal) firebox
No modification to the firebox
of the z.c. fireplace is allowed.
NOTE: It is
recommended your
chimney have a
minimum 28 and a
maximum of 144
square inch cross-
sectional area to use a
face seal connection,
otherwise your
chimney may not have
sufficient draw for the
fireplace insert to
operate correctly.
Airtight Insulated
Clean-Out
Remove damper
or wire it open
4090819
13