Travis Industries Lopi Answer Installation Instructions Manual

Compatibility (Freestanding Models Only)
• Lopi Answer • Lopi Endeavor
• Avalon Pendleton (745/790)
• 1250 Wood Stove
Packing List
• Rear Blower • Snap Disk Assembly
Operating Instructions
The blower will not turn on until the appliance is up to temperature. Once up to temperature, the blower will
operate at the speed determined by the position of the blower knob (see the illustration below). The blower
shuts off once the appliance cools.
Installation Instructions (All Except Leyden, Arbor, and 1750)
1. Install the stove legs or pedestal. Remove the two rear blower knock-outs underneath the base (see the
illustration below).
Drop Chute Knock-Out
- found on Olympic
(1190) and Rainier (990)
only.
2. For the Endeavor and Liberty follow step 2B. For all other models, follow step 2A.
2A Install the snap disk assembly into the left side convection chamber following the directions below.
Snap Disk
Assembly
Page 1 of 6
Rear Blower Installation Instructions
• Lopi Liberty
• Avalon Rainier (945/990)
• 1750 Wood Stove
• Snap Disk Hanger
OFF
Turn the knob
all the way
counter-
clockwise to
turn off.
FRONT OF STOVE
Wedge the snap disk
directly in front of the
stiffener on the left side.
Bend these legs on
the snap disk if it
does not fit tightly
17601035 - 8/18/10
99000138
• Lopi Leyden
• Avalon Olympic (1190) • Avalon Arbor
• Three 1/4" 20 Thread Cutting Screws
HIGH
Turn the knob
clockwise from
the off position
until it clicks.
Outside Air Knock-Out
for standard pedestals
Ashpan Pedestal/Air Boot
Outside Air Knock-Out
Rear Blower Knock-Outs
REMOVE THESE KNOCK-OUTS
Twist the wires together and feed them
through the convection chamber and
out of the knockout removed in step 1.
LOW
Turn the knob
all the way
clockwise to
turn to low.
© Travis Industries, Inc.