FujiFilm FinePix F601 Zoom Service Manual page 33

FinePix F601 Zoom (U/E/EG) SERVICE MANUAL
<Step5>
Follow instructions on the [3.20V Input Screen (Fig.8)],
and adjust BATT_END voltage. Set voltage to
3.20V(+0.02V, -0.00V), press the [Enter] key on the com-
puter.
---> The [5.80V Input Screen (Fig.9)] is displayed.
<Step 6>
Follow instructions on the [5.80V Input Screen (Fig.9)],
and adjust BATT_HIGH voltage. Set voltage to
5.80V(+0.02V, -0.00V), press the [Enter] key on the com-
puter.
---> The [5.00V Input Screen (Fig.10)] is displayed.
<STE7>
Follow instructions on the [5.00V Input Screen (Fig.10)],
a n d a d j u s t B A T T _ R E F v o l t a g e . S e t v o l t a g e t o
5.00V(+0.01V, -0.01V), press the [Enter] key on the com-
puter.
---> Save the adjusted data to the flash ROM when adjust-
ment is completed normally.
---> The [Battery Adjustment Complete Screen (Fig.11)] is
displayed when the adjusted data is saved normally.
<Step 8>
Press the [Enter] key on the computer while in the [Bat-
tery Voltage Adjustment Complete Screen (Fig.11)].
---> The [Adjustment Select Screen (Fig.4)] is displayed.
Always select [[F12]: End Setting] to complete adjust-
ment.
[Cautions when completing adjustment]
Cautions for adjustments other than battery voltage
adjustment.
(1) Mode Dial Voltage Adjustment
---> Select Mode Dial Voltage Adjustment from the Adjust-
ment Select Screen, and continue adjustment.
(2) Other than Mode Dial Voltage Adjustment
---> Perform the following after [F12]: End Setting.
1) Remove the [NP-60 battery jig] from the camera.
2) Connect the [Power cable jig] to the camera.
3) Set the camera in the jig mode again.
4) Select an adjustment other than Mode Dial Voltage
Adjustment from the Adjustment Select Screen, and
continue adjustment.
4. Adjustment
<Fig.8> 3.20V Input Screen
<Fig.9> 5.80V Input Screen
<Fig.10> 5.00V Input Screen
<Fig.11> Battery Adjustment Complete Screen
33