FujiFilm FinePix F601 Zoom Service Manual page 30

4. Adjustment
<STEP5>
Select [Hardware] on the [Customize] setup screen (Fig.I-
(1)).
Setup as follows on the [Hardware] menu (Fig.I-(2)).
Item
Debug Mode
<STEP6>
When the settings have been entered in the [EVR], [Oth-
er], and [Hardware] menus noted above, click on [Apply]
on the [Customize Dialog] screen (Fig.I-(3)) to terminate.
Further setup is unnecessary once the settings have
been applied.
(note) Setting [Don't show OK/NG] to OFF will allow [OK] to
be displayed on the computer screen if the adjust-
ment is successful, and [NG] to be displayed if it is
not (either setting can be used).
Cautions for Adjustment
(note 1) The end setting returns the camera to the
[Product Mode] from the [Jig Mode].
Always ensure that the camera is returned
to the [Product Mode] before use after us-
ing the computer adjustment software.
Unless this termination setting is selected,
[Mass Storage] will not be recognized
when the camera and computer are con-
nected, and communication with the com-
puter will be impossible.
(note 2) FinePix_F601 may be used with other dig-
ital cameras, however data read and write
is not possible.
It is possible to read data from other mod-
els, however this should not be attempted
under any circumstances.
See Table 1 at right.
30
Setup details
Select [Ignore Focus].
FinePix F601 Zoom (U/E/EG) SERVICE MANUAL
(2)
<Fig.I> Hardware Dialog Box Screen
Menu Command
Operation Start
Stop
Temporary stop
Step 0
Terminate
Program Reload
Select
Edit
Data ad[ ]
rd [ ]
SW
f s w
EVR
Mode Record file
NGSTOP
STEP
LINE
AUTO
Setting OK/NG clear
Mode set
Automatic
adjustment
Help Help
FF help
FOCAS
Version
<Table 1> FFWJ.exe Commands
* Do not change the content of the program FX_F601_UED.ff
under any circumstances. Any changes will prevent the
software running.
(1)
Fx_F601_UED.ff
Apply
(3)
Description
Program start
Program stop
Temporary program stop
Do not use.
Terminate program.
Reload program (*.ff).
Select program (*.ff).
Edit program (*.ff).
Do not use.
Do not use.
Do not use.
Do not use.
Do not use (Note 2).
Do not use.
Temporarily stops program
when adjustment is unsuc-
cessful.
Do not use.
Do not use.
Do not use.
Do not use.
Sets mode.
Runs 'Auto Adjust' inside the
user program.
Basic software help
User program help
Not used with this adjust-
ment software.
Version information for
basic software.