C8
AXLE GEOMETRY
Setting at reference height (continued)
Height of the vehicle at the rear at reference height (H2 = R2 + L2)
Engage the slings [4] on the rear longerons.
Position the suspension compressor [1] selecting the separation (a) most suited to pull
the straps as far upwards as possible.
Compress the suspension so as to obtain, on the RH and LH sides, the bodyshell height
H2 (reference height), to be measured between the bottom of the longeron « c » and the
C4BP1CND
ground.
WARNING : take account of pivoting surfaces when measuring the reference height H2.
Check that the height H1, measured already at the front, has not changed.
WARNING : The rear axle angles are not adjustable.
B3BP18GC
280