Ser Vice Journal; Pre-Deliv Ery Service; After The First 8 Hours - Jonsered FR2211R Operator's Manual

Pre-deliver y service
1 Charge the battery for 4 hours at max. 3 amp.
2 Fit steering wheel, seat and any optional equipment.
3 Check and adjust tyre pressure (60 Kpa, 0.6 bar, 9 PSI).
4 Adjust cutting unit:
Adjust lift springs (effective weight of cutting unit should be 12-15kg / 26.5-33 lb).
Adjust cutting unit so that rear edge is about 2-4 mm / 1/8" higher than front edge.
Adjust the cutting unit's cutting height setting so that the connection rod is tensed at the lowest cutting height.
5 Check that the right amount of oil is in the engine.
6 Check that there is oil in the transmission's oil tank.
7 Connect battery.
8 Fill with fuel and start engine.
9 Check that machine does not move in neutral.
10 Check:
Forward drive.
Reverse drive.
Operation of blades.
Seat safety switch.
Lif lever safety switch.
Safety switch for the hydrostat pedals/neutral position.
11 Check engine speed. See the Technical data section.
12 Check the synchronisation between the front and rear wheels. (Only 4x4-machines) See the workshop manual.
13 Tell customer about:
Needs and benefits of following the service schedule.
Servicing and the influence of this journal on the second-hand value of the machine.
Range of applications for Mulching.
Complete proof of sale etc.
Pre-delivery service carried out. No outstanding problems. Certified:
_____________________________________________________________________________________________
Date, mileage, stamp, signature
After the fi rst 8 hours
1 Change engine oil
2 Change the oil in the gearbox. (Only 4x4-machines)
3 Check the synchronisation between the front and rear wheels. (Only 4x4-machines)
4 –
English

Ser vice journal