Check The Contents Of The Box; Caution In Setting Up The Stand - Roland V-Drums TD-12KX Owner's Manual

Setup

Check the Contents of the Box

TD-12 (Drum Sound Module) x 1
VH-11 (V-Hi-Hat) x 1
KD-120 (V-Kick) x 1
PD-105 (V-Pad) x 2 (Snare, Tom 3)
PD-85 (V-Pad) x 2 (Tom1, Tom2)
CY-12R/C (V-Cymbal) x 2
Drum Key x 1
TD-12KX Owner's Manual (this manual) x 1
VH-11 Owner's Manual x 1
• The drum key is included in the VH-11 package.
• The TD-12 Owner's Manual is included in the TD-12 package.
• This package does not include a kick pedal and a hi-hat stand.
Use with a commercially available kick pedal and hi-hat
stand.
MDS-12X
(Drum Stand)
Assemble the Drum Stand.
About the Stand, refer to the MDS-12X Owner's Manual.

Caution in Setting Up the Stand

• Do NOT open the legs of the stand more than 120 degrees.
The distance between the back Right/Left end legs should
NOT be more than 1.3 m (51 inches), otherwise, the cable
(inside the Pipes) could be damaged and/or the stand could
tip over.
120˚
• Do NOT loosen any bolts other than Hand Knobs except
when changing the parts or cables for repairing.
120˚
1.3 m
TD-12
(Drum Sound Module)
Attach the stand holder (included with the drum stand MDS-
12X) to the TD-12.
Using the screws attached to the bottom panel, attach the
holder so the unit is oriented as shown in the diagram.
Stand holder
Narrow
• To attach the stand holder, remove the four 12 mm screws
(M5 x 12) from the bottom of the TD-12 and use them. Use of
other screws may result in damage to the unit.
928
• When turning the unit upside-down, get a bunch of
newspapers or magazines, and place them under the four
corners or at both ends to prevent damage to the buttons
and controls. Also, you should try to orient the unit so no
buttons or controls get damaged.
929
• When turning the unit upside-down, handle with care to
avoid dropping it, or allowing it to fall or tip over.
VH-11
(V-Hi-Hat)
Mount the VH-11 on a commercially available hi-hat stand.
Refer to the VH-11 Owner's Manual.
Wide
5