Check The Contents Of The Box; Caution In Setting Up The Stand - Roland V-Drums TD-12K Owner's Manual

Check the Contents of the
Box
❑ TD-12 (Percussion Sound Module) x 1
❑ VH-11 (V-Hi-Hat) x 1
❑ KD-85 (V-Kick Trigger Pad) x 1
❑ PD-105 (V-Pad) x 1
❑ PD-85 (V-Pad) x 3
❑ CY-12R/C (V-Cymbal Ride/Crash) x 2
❑ Tuning Key x 1
❑ VH-11 Owner's Manual
■ TD-12K Owner's Manual (this manual) x 1
• The tuning key is included in the VH-11 package.
• The TD-12 Owner's Manual is included in the TD-12
package.
• This package does not include a kick pedal and a hi-hat
stand. Use with a commercially available kick pedal and
hi-hat stand.
MDS-12
(Drum Stand)
Assemble the Drum Stand.
About the Stand, refer to the MDS-12 Owner's Manual.

Caution in Setting Up the Stand

• Do NOT open the legs of the stand more than 135
degrees. The distance between the back Right/Left end
legs should NOT be more than 1.5 m (60 inches),
otherwise, the cable (inside the Pipes) could be damaged
and/or the stand could tip over.
135˚
• Do NOT loosen any bolts other than Hand Knobs except
when changing the parts or cables for repairing.
135˚
1.5 m
TD-12
(Percussion Sound Module)
Attach the stand holder (included with the drum stand MDS-
12) to the TD-12.
Using the screws attached to the bottom panel, attach the
holder so the unit is oriented as shown in the diagram.
Narrow
• To attach the stand holder, remove the four 12 mm
screws (M5 x 12) from the bottom of the TD-12 and use
them. Use of other screws may result in damage to the
unit.
928
• When turning the unit upside-down, get a bunch of
newspapers or magazines, and place them under the four
corners or at both ends to prevent damage to the buttons
and controls. Also, you should try to orient the unit so no
buttons or controls get damaged.
929
• When turning the unit upside-down, handle with care to
avoid dropping it, or allowing it to fall or tip over.
VH-11
(V-Hi-Hat)
Mount the VH-11 on a commercially available hi-hat stand.
Refer to the VH-11 Owner's Manual.
IMPORTANT NOTES
Wide
5