Roland V-Drums TD-12KX Owner's Manual page 7

Assembling the KD-120
1.
Place the KD-120 pad, with the head surface facing
downward, on a flat surface such as the floor.
2.
Use the included drum key to loosen and remove
the bolts for the brackets on the back of the KD-120
pad.
3.
Mount the stand on the brackets so that the output
jack for the KD-120 pad faces up.
Use the bolts you removed earlier to secure the KD-120 pad
to the stand, tightening the bolts with the included drum
key.
fig.08.e
Bracket
* Take care not to pinch your fingers between the KD-120 pad
and the stand plate.
4.
Adjust the ends of the legs to match the location
where you're installing the KD-120.
Adjust to use the spike legs when installing on carpeting or
other soft surfaces, or the rubber legs when installing on
flooring or other hard surfaces.
When shipped from the factory, the stand is adjusted for
using the rubber legs. If you're using the rubber legs, proceed
to step 5 on the next page.
Adjusting for the Spike Legs
1.
2.
3.
Adjusting for the Rubber Legs
1.
2.
3.
5.
fig.11.e
Output jack
6.
7.
8.
9.
Loosen the leg nut.
Turn the rubber foot to
adjust so that the spike
portion sticks out from
the rubber foot. Adjust the length of the spike
to suit the location where installing and the
length you prefer.
* The tip of the spike is sharp. Handle it with care.
Tighten the nut to secure the rubber foot in
place and keep it from loosening.
* When using on flooring, the spike legs may damage
the floor. Adjust to use the rubber legs.
Loosen the leg nut.
Turn the rubber foot to
adjust so that the spike
portion does not stick
out from the rubber foot.
Tighten the nut to secure the rubber foot in
place and keep it from loosening.
Loosen the T-bolts for the stand and mount the
legs on the stand.
Install the legs as shown in the figure so that the ends of the
legs protrude by about 2 cm.
Mount the
legs on the stand.
T-bolt
Tighten the T-bolts to secure the legs to the stand.
Lift the KD-120 and place the stand and the four
legs upright.
Adjust the angle of the head surface so that it's at a
right angle to the floor.
Use the included drum key to loosen the bracket bolts you
tightened in step 3, and adjust the angle of the KD-120 pad
so that the head surface is at a right angle to the floor.
Attach the included plastic beater on your kick
pedal.
Nut
Rubber foot
Spike
Nut
Rubber foot
Extend the leg by about 2 cm.
7