Page 1
CY-13R V-CYMBAL RIDE CY-12C V-CYMBAL CRASH Owner’s Manual Before using this unit, carefully read the sections entitled: “USING THE UNIT SAFELY” and “IMPORTANT NOTES” (p. 2; p. 3). These sections provide important information concerning the proper operation of the unit. Additionally, in order to feel assured that you have gained a good grasp of every feature provided by your new unit, Owner’s manual should be read in its entirety.
(except when this manual provides specific instructions directing you to do so). Refer all servicing • In households with small to your retailer, the nearest Roland children, an adult should provide supervision until the Service Center, or an authorized Roland distributor, as listed on the “Information”...
6 Roland,V-Drums, and V-CYMBALS are registered trademarks of that has been slightly dampened with water. To remove stubborn Roland Corporation in the United States and/or other countries. dirt, use a cloth impregnated with a mild, non-abrasive detergent. Afterwards, be sure to wipe the unit thoroughly with a soft, dry cloth.
* The CY-13R is not capable of detecting the striking position. Weight 940 g / 2 lbs 2 oz If you’re using a Roland percussion sound module that is capable Owner’s manual, Wing nut, Felt washer, of detecting the striking position, you’ll need to set the ride’s Position Ctrl to OFF.
OUTPUT jack the performer’s perspective. Attach the V-Cymbal, while positioning it BOW/EDGE BOW/EDGE so the Roland logo is located on the side OUTPUT jack OUTPUT jack opposite the performer. RD cable CR1, 2 cable (TD-9, TD-4) (TD-9, TD-4)
If you choke an area where there is no sensor, the Edge sensor sound does not stop. Roland logo Edge sensor * On the CY-13R, edge shots are possible when the connection is made to the BOW/EDGE OUTPUT jack.
Page 7
Trigger Parameter Settings for the Percussion Sound Module Recommended Settings for the Trigger Parameters These are the recommended trigger parameter settings when using the V-Cymbal with various models of sound module. You may need to adjust the trigger parameters depending on how you’ve attached the V-Cymbal and the location at which you’ve installed it.