Freestanding Installations - Rinnai Neo RIB2310N Installation Manual

Freestanding installations

While the following diagrams depict the Neo Freestanding Console model, the steps to
constructing the Neo Freestanding Plinth are the same.
1. Attach the flue spigot to the Neo engine
Using a 3.3 mm drill bit, drill through the four dimples at the rear of the back panel of the Neo
engine. Attach the flue spigot (ordered separately) with the screws provided.
Attach flue spigot
2. Assemble, position and secure base assembly to the floor
Assemble the base assembly provided in the Neo freestander kit and place on the floor where
the Neo is to be located. Using three appropriate bolts or screws secure the base assembly to
the floor. This also acts as a seismic constraint.
The diagram below shows the base assembly for the Neo Console model. The Neo Plinth base
assembly has a pillar section attached.
Rinnai New Zealand Limited
18
Neo Installation Manual: 11906-B
02-11