Selec. Of Senders (Users)" Setting - Oce OP1030 Operation Manual

1-3 Using the Scanner Function

1-3-7 "Selec. of senders (users)" setting

Normally, when using the scanner you must first perform the procedure to select the user. However, the
"Selec. of senders (users)" setting is convenient when scanner use is restricted to certain users because, if
you register a user under User Number 001 and then turn this setting ON, you can skip that selection
procedure and use the scanner right away.
* If the "Selec. of senders (users)" setting is turned ON but User Number 001 is not registered, an error
* This function is only available with scanners that possess a touch panel.
<Making the default setting>
1 . Press the default (*) key on the scanner's operation panel and then access the System Basic screen on
2 . Use the " " and " " cursor keys to select "Selec. of senders (users)" and then touch the "Change #"
message will appear and scanning will not be possible.
the touch panel. Refer to "(3) Making settings from the touch panel" on page 2-2 of the Set-Up Edition of
your Operation Guide for the procedure on accessing the System Basic screen.
key. The Change Settings screen will appear.
Page 1-33