Test The Telephone Line Connection; Set Up The Accessory Handset - Radio Shack 43-337 User Manual

Test the Telephone Line Connection

3
1. Pick up the corded handset from the base. The phone should pick up line 1
automatically and change the display to show
a dial tone.
2. When you get a dial tone, make a test call.
If...
the display says
you don't hear a dial tone
you keep hearing a dial tone
there's a lot of noise or static
3. Once you can make calls on line 1, make a test call
on the second line. Pick up the corded handset
and press the unmarked key under
should hear a dial tone and the display should
show .
Talk
If...
the display says
you don't hear a dial tone
you keep hearing a dial tone

Set Up the Accessory Handset

4
1. Press down and slide the battery cover off.
2. Lift the battery pack out of the compartment.
Try...
checking the connection between the base and
Check or
the phone jack: make sure the cord is connected to
TEL LINE 1/2.
setting line 1 to pulse dialing. (See "Changing from
Tone to Pulse Dialing" on page 9.)
see "Resetting and Registering Handsets" on page 42 for
tips on avoiding interference.
LINE2
Try...
checking the connection between the base and the
Check or
phone jack: if you have a separate jack for each line,
make sure the cord is connected to TEL LINE 2.
setting line 2 to pulse dialing. (See "Changing from
Tone to Pulse Dialing" on page 9.)
3. Line up the battery pack
connector with the jack
inside the handset.
(The battery connector will only fi t one way.)
4. Push the battery pack connector in until it clicks
into place. Tug gently on the wires to make sure
the battery pack is securely connected.
, and you should hear
Talk
. You
7
SUN 12:00A
0
12/31/08
0