Fcc Information - Radio Shack 43-337 User Manual

FCC Information

Any changes or modifi cations not expressly approved by the party responsible for compliance could
void the user's authority to operate this device.
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA.
On the bottom of this equipment is a label that contains, among other information, a product identifi er
in the format US: AAAEQ##TXXXX. If requested, this number must be provided to the telephone
company. An applicable Universal Service Order Codes (USOC) certifi cation for the jacks used in this
equipment is provided (i.e., RJ11C) in the packaging with each piece of approved terminal equipment.
A plug and jack used to connect this equipment to the premises wiring and telephone network must
comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA.
A compliant telephone cord and modular plug is provided with this product. It is designed to be con-
nected to a compatible modular jack that is also compliant. See installation instructions for details. The
REN is used to determine the number of devices that may be connected to a telephone line. Excessive
RENs on a telephone line may result in the devices not ringing in response to an incoming call. In most
but not all areas, the sum of RENs should not exceed fi ve (5.0).
To be certain of the number of devices that may be connected to a line, as determined by the total
RENs, contact the telephone provider. For products approved after July 23, 2001, the REN for this
product is part of the product identifi er that has the format US:AAAEQ##TXXXX. The digits repre-
sented by ## are the REN without a decimal point (e.g., 03 is a REN of 0.3). For earlier products, the
REN is separately shown on the label.
If this equipment causes harm to the telephone network, the telephone company will notify you in
advance that temporary discontinuance of service may be required. But if advance notice isn't practical,
the telephone company will notify the customer as soon as possible. Also, you will be advised of your
right to fi le a complaint with the FCC if you believe it is necessary. The telephone company may make
changes in its facilities, equipment, operations or procedures that could affect the operation of the
equipment. If this happens the telephone company will provide advance notice in order for you to
make necessary modifi cations to maintain uninterrupted service.
Please follow instructions for repairing if any (e.g. battery replacement section); otherwise do not
alternate or repair any parts of device except specifi ed.
Connection to party line service is subject to state tariffs. Contact the state public utility commission,
public service commission or corporation commission for information.
This equipment is hearing aid compatible.
NOTICE: If your home has specially wired alarm equipment connected to the telephone line, ensure
the installation of this equipment does not disable your alarm equipment. If you have questions about
what will disable alarm equipment, consult your telephone company or a qualifi ed installer.
If trouble is experienced with this equipment, for repair or warranty information, please contact a
Factory Service Center or other Authorized Servicer. If the equipment is causing harm to the telephone
network, the telephone company may request that you disconnect the equipment until the problem is
resolved.
NOTICE: According to telephone company reports, AC electrical surges, typically resulting from
lightning strikes, are very destructive to telephone equipment connected to AC power sources. To
minimize damage from these types of surges, a surge arrestor is recommended.
RF exposure information
This product complies with FCC radiation exposure limits set forth for an uncontrolled environment.
• To comply with FCC RF exposure requirements, the base unit must be installed and operated 20 cm
(8 inches) or more between the product and all person's body (excluding extremities of hands, wrist
and feet).
• This product may not be collocated or operated in conjunction with any other antenna or transmitter.
• The handset may be carried and operated with only the specifi c provided belt-clip. Other non-tested
belt-clips or similar body-worn accessories may not comply and must be avoided.
This device complies with part 15 of the FCC rules. Operation is subject to the following two condi-
tions: (1) This device may not cause harmful interference, and (2) This device must accept any interfer-
ence received, including interference that may cause undesired operation. Privacy of communications
may not be ensured when using this phone.
45