Storage; Eral Inspection - BOMBARDIER Mirage Operator's Manual

Taillight Bulb Replacement
If taillight bulb is burnt, expose the
bulb by removing the red plastic lens.
To remove, unscrew the two (2) Phil-
lips head screws.
.... WARNING: Always check light
.... operation after bulb replacement.
General Inspection
Check the electrical wiring and compo-
nents, retighten loose connections.
Check for stripped wires or
rl':HY\'::lr'lorl
insulation. Thoroughly inspect the ve-
hicle and tighten loose bolts, nuts and
linkage. skis and ski runners for
wear.
STORAGE
It is during summer, or when a vehicle
is not in use for any length of time that
proper storage is a Storage
of the snowmobile during long period
of inactivity consists of checking and
replacing missing, broken or worn
parts, proper lubrication and treatment
to insure that parts do not become
rusted; cleaning items such as carbu-
retor of oil mixtures, to prevent gum
varnish formation within the carbure-
tor; and in general, preparing the vehi-
cle so that when the time comes to use
the snowmobile again it will start and
be in top condition.
.... WARNING: Only perform such
.... procedures as detailed in this
manual. It is recommended that dealer
assistance be periodically obtained on
other components/systems not cov-
ered in this manual. Unless otherwise
specified, engine should be turned OFF
for all lubrication and maintenance pro-
cedures.
Track
Inspect the track for wear, cuts, miss-
ing track guides and broken rods.
Make any necessary replacement .
.... WARNING: Do not operate a
.... snowmobile with a cut, torn or
damage track.
Lift the rear of vehicle until track
;s
clear of the ground then support with a
brace or trestle. The snowmobile should
be stored in such a way that the track
does not stay in contact with the cement
floor or bare ground.
O
NOTE: The track should be rotat-
ed periodically
t
(every 40 days).
Do not release track tension.
tIP
CAUTION: To prevent track dam-
'Y
age, temperature in the storage
area must not exceed 38°C (100°F).
Suspension
Remove any dirt or rust. Grease idler
wheels at grease fittings. Wipe off sur-
plus. Replace worn slider shoes.
31