BOMBARDIER Mirage Operator's Manual page 13

OFF
Electric Start Models
+
WARNING: If the switch has
been used in an emergency situa-
tion the source of malfunction should
be determined and corrected before re-
starting engine .
F)
Light Switch (Electric Start
Models)
A push pull switch type, to illuminate
head/amp and taillight, pull switch
knob. (Ignition switch must be turned
to ON position).
G) Manual Starter Handle
Auto rewind type located on right hand
side of vehicle. For proper operation,
refer to Starting Procedure p. 16.
H) Primer
A push-pull button. Pull and push but-
ton (2-3 times] to activate primer. The
primer should always be used for cold
engine starts. After engine is warm
however
f
it is not necessary to use
primer when starting.
I)
Tether Cut-Out Switch
Attach tether cord to wrist or other
convenient location then snap tether
cut-out cap over receptacle before
starting engine.
If emergency engine "shut off" is re-
quired, completely pull cap from safety
switch and engine power will be auto-
matically shut " o ff " .
O
NOTE: The cap must be installed
on the safety switch at all times in
order to operate the vehicle.
.". ON
- START
OFF
~~=ON-~--
A 3 position switch located on the right
side of the handlebar. To stop the en-
gine in an emergency, flick the lever to
either upper or lower "0 FF" position.
To start engine, lever must be in mid-
dle "Olv" position.
.£..
WARNING: For safety reasons,
~
the emergency cut-off switch is
easily accessible; be careful not to
operate it inadvertently.
The driver of this vehicle should fami-
liarize himself with the function of this
device by using it several times on first
outing. Thereby being mentally pre-
pared for emergency situations re-
quiring its use.
Key operated, 3 position switch. To
start engine, turn key fully clockwise to
START position and hold. Return key
to ON position immediately when en-
gine has started. To stop engine, turn
key counter-clockwise to OFF position.
. . . CAUTION: Holding key in START
y
position when engine has started
could damage starter mechanism.
D) Headlamp Dimmer Switch
The dimmer switch, located on left
side of handlebar, allows correct selec-
tion of headlamp beam. To obtain high
or low beam simply flick switch.
E) Emergency Cut-Out Switch
11