BOMBARDIER Mirage Operator's Manual page 32

To adjust, remove the four caps, turn
upper or lower adjusting screws to ob-
tain desired beam position.
Adjusting
screws
Adjusting
screws
Headlamp
horizontal
center line
With the suspension correctly adjusted,
the rider seated on the vehicle and the
high beam ON check that the center of
high intensity zone of high beam is 50
mm (2") below horizontal line of head-
lamp height.
Headlamp Bulb Replacement
If the headlamp bulb is burnt, tilt hood,
unplug the connector from the head-
lamp. Remove the rubber boot and un-
fasten bulb retainer clips. Detach the
bulb and replace.
Following sequence above shown, tor-
que engine head nuts twice.
IMPORTANT: The engine head nut tor-
que should be checked after the first 5
hours of operation.
Engine Mount Nuts
Check the engine mount nuts for tight-
ness. Retighten if necessary.
Headlamp Beam Aiming
The angle of the headlamp beam has
been pre-adjusted prior to delivery.
Should you wish re-adjustment, place
the vehicle on a flat surface 7.6 m (25')
from a wall or screen.
Engine Head Nuts
With the ENGINE COLD, check that
the engine head nuts are tight and
equally torqued to 22
N.m
(16 ft-Ibsl.
TOP VIEW
SIDE VIEW
Ground
30