Pre-Start Check; Check Points; Starting Procedure - BOMBARDIER Mirage Operator's Manual

PRE-START CHECK STARTING PROCEDURE
Check Points
• Activate the throttle control lever
several times to check that it oper-
ates easily and smoothly. The throt-
tle control lever must return to idle
position when released.
• Check fuel level.
• Check injection oil level.
• Check that the skis and the track are
not frozen to the ground or snow
surface and that
'"'+,....'"' .., ... ~'"
operates
freely.
• Activate the brake control lever and
make sure the brake fully be-
fore the brake control lever touches
the handlebar grip.
• Verify that the path ahead of the ve-
hicle is clear of bystanders and ob-
stacles .
.&
WARNING: Only start your snow-
.... mobile once all components are
checked and functioning properly.
16
Manual Starting
1. Insert the key in the ignition switch
and turn to ON position.
2.
TEST THROTTLE CONTROL LE-
VER.
3. Activate the primer (2 or 3 times).
O
NOTE: The use of the is
not necessary when en-
is warm.
4. Make sure that the tether cut-out
cap is in position and that the cord is
attached to your clothing. Check
that the emergency cut-out switch
is in the center ON position.
OFF
ON
5. Grasp manual starter handle
and pull slowly until a resistance
felt then pull vigorously. Slowly re-
lease the rewind starter handle .
.&
WARNING: Do not apply throttle
..... while starting.
6. Check the operation of the erner-
cut-out switch and the tether
o vv
t
rx-
r r •
Restart the engine .
.&
WARNING: If engine does not
..... shut-off when applying the emer-
gency cut-out switch and pulling the
tether cut-out cap, stop the engine by
turning off the ignition key. Do not
operate the vehicle further, see your
dealer.
7. Allow the engine to warm before
operating at full throttle.