Clifford Arrow 5 Installation Manual page 9

h1/13 and h1/14 white parking light output
These wires are the output of an on-board dual make relay and should be connected
to wires in the vehicle that control the parking light wire polarity. The dual outputs are
designed for European vehicles with isolated parking light systems. If the vehicle's
parking lights are controlled by a single wire, connect both WHITE wires to it.
I I M M P P O O R R T T A A N N T T ! ! The polarity of this wire is determined by the connection of the H1/12
light flash input wire. Always confirm light flash polarity before connecting H1/12 or
damage to the vehicle lighting system could occur.
h1/15 black/white (-) dome light supervision output (200mA)
Connect the H1/15 BLACK/WHITE wire to the optional domelight supervision relay
as shown in the following diagram.
I I M M P P O O R R T T A A N N T T ! ! This output is only intended to drive a relay. It cannot be connected
directly to the domelight circuit, as the output cannot support the current draw of one
or more bulbs.
© 2004 directed electronics, inc.
9