Installing Optional Clutch Extension Handles - Invacare Wheelchair Owner's Operator And Maintenance Manual

PROCEDURE 11
INSTALLING OPTIONAL CLUTCH
EXTENSION HANDLES (FIGURE 11)
R
1. Turn the power to the wheelchair to the OFF position.
W
2. Position the clutch extension handle by the clutch
D
handle on the motor as shown in FIGURE 11.
W
NOTE: If the clutch handle on the motor is equipped with
H
a rubber tip, remove the rubber tip before installing the
E
clutch extension handle.
E
3. Slide clutch extension handle onto motor clutch handle.
L
NOTE: If necessary, lightly tap the clutch extension handle
C
onto the clutch handle with a plastic mallet. Make sure the
H
vertical portions of both handles are in line.
A
4. Securely tighten set screw on clutch extension handle.
I
5. Repeat STEPS 2-4 for opposite side of wheelchair.
R
S
Clutch
Extension
Handle
Set Screw
FIGURE 11 - INSTALLING OPTIONAL CLUTCH
EXTENSION HANDLES
44
RWD WHEELCHAIRS
Remove
Rubber Tip
if Equipped
Clutch
Handle
Motor
NOTE: Make sure vertical
portions of both handles are
in line.