Removing/Installing Shrouds - Invacare Wheelchair Owner's Operator And Maintenance Manual

PROCEDURE 10

REMOVING/INSTALLING SHROUDS

(FIGURE 8)
F
Removing Front Shroud
W
D
1. Unclip the retaining strap securing the front shroud
and battery box to the wheelchair.
W
2. Feed the retaining strap through the front shroud.
H
3. Remove the front shroud from the wheelchair.
E
E
Installing Front Shroud
L
1. Feed the retaining strap through the front shroud as
C
shown in FIGURE 8.
H
2. Position the bottom of the front shroud between the
A
battery box and the battery tray.
I
3. Clip the retaining strap together.
R
S Removing Rear Shroud
1. Unclip the retaining strap securing the rear shroud
and battery box to the wheelchair.
2. Feed the retaining strap through the rear shroud.
3. Remove the rear shroud from the wheelchair.
Installing Rear Shroud
1. Feed the retaining strap through the front shroud as
shown in FIGURE 8.
2. Clip the retaining strap together.
Retaining Strap
Rear Shroud
Wheelchair
Frame
Phillips Bolts
Phillips Screws
Filler
Battery Box
FIGURE 8 - REMOVING/INSTALLING SHROUDS - FWD WHEELCHAIRS
3. Press down on the rear shroud until the two (2) clips
secure the rear shroud to the two (2) side shrouds.
Removing Side Shrouds and Fillers
1. Remove the front shroud from the wheelchair. Refer
to REMOVING/INSTALLING FRONT SHROUD in
this procedure of the manual.
2. Remove the rear shroud from the wheelchair. Refer
to REMOVING/INSTALLING REAR SHROUD in this
procedure of the manual.
3. Perform one (1) of the following:
A. INTEGRATED SLING SEAT MODELS - Fold
the wheelchair. Refer to TRANSPORTING EX-
CEL in this procedure of the manual.
B. CAPTAIN'S SEAT MODELS - Remove the
Captain's Seat from the wheelchair. Refer to
REMOVING/INSTALLING CAPTAIN'S SEAT in
this procedure of the manual.
4. Remove the phillips screws, bolts, washers and lock-
nuts that secure side shroud and filler to the wheel-
chair frame. Refer to FIGURE 8 for phillips screw
and washer locations.
5. Remove the side shroud and filler from the wheelchair.
6. Repeat STEPS 4-5 for the opposite side of the wheel-
chair, if necessary.
Locknut
Retaining Strap
32
FWD WHEELCHAIRS
Phillips Screws
Side Shroud
Washers
Battery Charger
Cover
Front Shroud
Battery Tray