Adjusting Footplate Height - Invacare TRACER EX2 User Manual

5.2 Adjusting Footplate Height

Spring Button
 This procedure applies to the swingaway front riggings
and swingaway elevating legrest.
1. Remove the front rigging assembly. Refer to Installing/Removing
Front Riggings on page 31.
 Lay the front rigging assembly on a flat surface to simplify
this procedure.
2. Pull the cam lock lever up to unlocked position.
 The elevating legrest has two sets of release buttons,
one set above the other. Each set will be visible one
at a time allowing finer footplate height adjustment.
3. Push in the release buttons and reposition the footplate assembly
to the desired height.
4. Ensure that the release buttons fully protrude from holes on both
sides of the front rigging support.
5. Rotate cam lock lever down to locked position.
6. Repeat this procedure for the other footplate, if necessary.
7. Reinstall the swingaway front rigging assembly. Refer to Installing/
Removing Front Riggings on page 31.
Part No 1110546
Adjustment
Holes
Cam Lock Lever

Swingaway footrest shown
FIGURE 2 Adjusting Footplate Height - Spring Button
33
5 FRONT RIGGINGS
Front Rigging Support
Release Button
Footplate
Assembly
®
Invacare Tracer™ EX2 Wheelchair