Toshiba E-Studio 2330c Troubleshooting Manual page 46

1 TROUBLESHOOTING FOR THE HARDWARE
6
Remove the jammed staples.
A: Stapling area
Do not touch the stapling area
The actual needle point could cause you personal injury.
7
Push the knob (2) to return it to its original position.
Make sure that the lever (1) is latched on the shutter.
8
Fit the staple cartridges.
Push down each cartridge until it is fixed with a click.
9
Unlock the stapler by pulling its handle toward you.
Then return the stapler to its original position.
10
Carefully insert the Saddle Stitch unit into the
Finisher.
11
Make sure of the following two requirements before test stapling:
The Finisher is securely attached to the equipment.
A3, B4, A4-R, LD, or LT-R paper is set in the drawer.
44 Clearing a Staple Jam
A
2 1
2
1