Toshiba E-Studio 2330c Troubleshooting Manual page 25

1.TROUBLESHOOTING FOR THE HARDWARE
When the Hole Punch Unit MJ-6101 is installed
5
Open the Hole Punch Unit cover.
6
Remove the paper by turning the knob.
7
Close the Hole Punch Unit cover.
8
Close the Bridge Unit cover.
9
Close the upper receiving tray of the Finisher.
Place your hands on the near and far side of the lever and push to
close the tray until it clicks.
Be careful not to let your fingers be caught between the
Finisher body and the upper tray of the Finisher.
This could injure you.
The upper receiving tray can also be closed by pressing the right
side of the lever.
1 TROUBLESHOOTING FOR THE HARDWARE
Clearing a Paper Jam 23