Installing/Removing/Using The Walker Holder - Invacare Lynx L-4 User Manual

12.4 Installing/Removing/Using the Walker Holder

WARNING
After ANY adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely.
The installation of the walker holder onto the back of the scooter seat significantly increases the length of the scooter.
When turning the scooter or swiveling the scooter seat, it is important to take note of this increased length - otherwise,
injury and/or damage to the surrounding property may result.
 For this procedure, refer to FIGURE 12.4.
Installing/Removing the Walker Holder

Reverse this procedure to remove the walker holder.
1. If necessary, loosen but DO NOT remove the mounting knob.
2. Install the walker holder into the accessory tube.
3. Thread the mounting knob into the welded nut on the accessory
tube. Securely tighten.
Using the Walker Holder
1. Fold walker. Refer to walker instructions.
 Walker MUST be folded before using walker
holder.
2. Hang folded walker on walker holder hooks.
3. Secure walker with hook and loop straps.
Part No. 1143205
Walker Holder
Accessory
Hook
Hook and
Loop Strap
FIGURE 12.4 Installing/Removing the Walker Holder
49
12 ACCESSORIES
Tube
Mounting
Knob
Insert Into
Accessory Tube
Lynx™L-3 & Lynx L-4 Scooters