7.4
Adjusting the Arm Width
For this procedure, refer to FIGURE 7.4 on
page 33.
When installing the arms during set up, the four
mounting screws are installed on the seat hinge for
shipping purposes.
1.
Loosen the knob securing the arm tube to the seat frame.
2.
Push the arm in or out to the desired position.
7.5
Replacing Armrest Pads
For this procedure, refer to FIGURE 7.5.
1.
Remove the two mounting screws that secure the armrest pad to
arm.
2.
Remove the old armrest pad.
3.
Install new armrest pad and securely tighten with existing mounting
screws.
4.
If necessary, repeat STEPS 1-3 to replace the other armrest pad.
Part No. 1143205
Lynx L-3 shown. Lynx L-4 adjusts the same way.
Seat
Frame
FIGURE 7.4 Adjusting the Arm Width
Mounting
FIGURE 7.5 Replacing Armrest Pads
33
7 SEAT AND ARMS
Arm
Arm
Tube
Knob
Arm Pad
Arm
Lynx™L-3 & Lynx L-4 Scooters