Table of Contents
Advertisement
PARTS NAMES
1
2
1
ADJ.
MOUNTING THE LENS
L
English
Flange-back adjustment
If the pick-up surface is not correctly positioned with relation to
the lens focal point, the picture will be out of focus (in particular
when using auto-iris power zoom lenses, sold separately). If that
is the case, adjust the flange-back position as described below.
1
Using a + screwdriver, loosen the FLANGE BACK LOCK
screw (M2:+).
LOCK
Set the zoom lens to the maximum telephoto position, set
the focus using the focus ring on the lens.
3
2
Set the zoom lens to the maximum wide angle position, set
the focus using the FLANGE BACK ADJ. screw.
3
Repeat steps 2 and 3, until the image stays in focus when
changing from a telephoto shot to a wide angle shot.
When the setting is complete, tighten the FLANGE BACK
LOCK screw.
Check the lens mount
Do not use a lens if the length "
may damage the camera and prevent proper installation.
Installation of a DC type auto-iris lens (sold
separately)
A 1/3 inch CS mount type lens without EE amplifier circuit that
only uses a DC power source. This camera can receive (the A.I.
LENS switch to the DC type) a CS mount type lens without the
need of an adaptor.
If the lens plug shape or wiring does not correspond, please
install the supplied plug as indicated in the pin layout table.
7
L
5
" is more than
mm. That
Advertisement
Chapters
Table of Contents
