Table of Contents
Advertisement
ADJUSTMENTS
1. SYNC
1-1. V sync phase adjustment
When using a camera switcher to connect 2 cameras or more to
one monitor, there may be a vertical roll of the images when
switched. In such a case, set as described below.
1
Set the SYNC switch (4) to L-L.
The on-screen setting will automatically switch to L-L. Press
the CURSOR (j or l) button to select the on-screen L-L
setting (get it flashing), then press the SET button. The
adjustment sub-menu "ADJUSTMENT FOR L-L" will be
displayed.
CURSOR
LL
INT
2
Switch the display on the monitor from camera 1 to camera 2.
Press the CURSOR (d or c) button until the vertical sync
phase is obtained. The on-screen marker (b) will move and
the adjustment value will flash according to the vertical sync
phase setting.
CURSOR
Note:
When an adjustment is made, the PRESET setting will
automatically switch to OFF. To return to the initial value, just
return the PRESET setting to ON, then press the SET button.
3
When finished.
1
Press the CURSOR (j or l) button to select END (get it
flashing), then press the SET button to return to the
normal camera display, or
2
Press the CURSOR (j or l) button to select MENU (get
it flashing), then press the SET button to return to the
"MENU FOR ADJUSTMENT" display.
English
SET
MENU FOR ADJUSTMENT
SYNC
IRIS
BLC
15
ADJUSTMENT FOR L-L
L-L
AI
ON
ADJUSTMENT FOR L-L
PRESET
END
1
(V SYNC PHASE)
o------z------p 524
(V SYNC PHASE)
o------z------p 415
OFF
MENU
2
Advertisement
Chapters
Table of Contents
