Mounting The Lens - Sanyo VCB-3372 Instruction Manual

PARTS NAMES
G
F
1
2 1
ADJ.

MOUNTING THE LENS

L
English
F
Flange-back adjustment screw (FLANGE BACK ADJ.)
G
Flange-back lock screw (FLANGE BACK LOCK)
Flange-back adjustment
If the pick-up surface is not correctly positioned with relation
to the lens focal point, the picture will be out of focus (in
particular when using auto-iris power zoom lenses, sold
LOCK
separately). If that is the case, adjust the flange-back position
as described below.
3
1
Using a + screwdriver, loosen the FLANGE BACK LOCK
screw (M2:+).
Set the zoom lens to the maximum telephoto position,
set the focus using the focus ring on the lens.
2
Set the zoom lens to the maximum wide angle position,
set the focus using the FLANGE BACK ADJ. screw.
3
Repeat steps 2 and 3, until the image stays in focus when
changing from a telephoto shot to a wide angle shot.
When the setting is complete, tighten the FLANGE
BACK LOCK screw.
Check the lens mount
Do not use a lens if the length "
That may damage the camera and prevent proper
installation.
Installation of a DC type auto-iris lens (sold
separately)
A 1/3 inch CS mount type lens without EE amplifier circuit
that only uses a DC power source. This camera can receive
(the A.I. LENS switch to the DC type) a CS mount type lens
without the need of an adaptor.
If the lens plug shape or wiring does not correspond, please
install the supplied plug as indicated in the pin layout table.
5
L 7
" is more than mm.