Table of Contents
Advertisement
General Settings
Policy Name
Enable Policy
Allow Net-
BIOS traffic
Remote VPN
Endpoint
Keys
2. Click Next to continue. You will see a screen like the following:
Figure 46: VPN Wizard – General Screen
Enter a suitable name. This name is not supplied to the remote
VPN. It is used only to help you manage the policies.
Enable or disable the policy as required. For each remote VPN,
only 1 policy can be enabled at any time.
Enable this if you require NetBIOS traffic to be transferred through
the VPN tunnel. NetBIOS is used by Microsoft (Windows) network-
ing. This setting should not be enabled unless necessary, because
it increases traffic volume.
The Internet IP address of the remote VPN endpoint (Gateway or
client).
Dynamic. Select this if the Internet IP address is unknown. In
this case, only incoming connections are possible.
Fixed. Select this if the remote endpoint has a fixed Internet IP
address. If selected, enter the Internet IP address of the re-
mote endpoint.
Domain Name. Select this if the remote endpoint has a Do-
main Name associated with it. If selected, enter the Domain
Name of the remote endpoint.
Select Manually assigned or IKE (Internet Key Exchange) as
required.
If you are setting up both endpoints, using IKE is recommended.
69
Microsoft VPN
Advertisement
Table of Contents
