LevelOne FBR-1430 User Manual page 33

VPN Broadband Router User manual
Data - PPPoE Screen
Connection
Physical Address
IP Address
Network Mask
PPPoE Link Status
Connection Log
Connection Log
Buttons
Connect
Disconnect
Clear Log
Refresh
Figure 19: PPPoE Status Screen
The hardware address of this device, as seen by remote
devices on the Internet. (This is different to the hardware
address seen by devices on the local LAN.)
The IP Address of this device, as seen by Internet users.
This address is allocated by your ISP (Internet Service
Provider).
The Network Mask associated with the IP Address above.
This indicates whether or not the connection is currently
established.

If the connection does not exist, the "Connect" button
can be used to establish a connection.

If the connection currently exists, the "Disconnect"
button can be used to break the connection.

The Connection Log shows status messages relating to
the existing connection.

The most common messages are listed in the table
below.

The "Clear Log" button will restart the Log, while the
Refresh button will update the messages shown on
screen.
If not connected, establish a connection to your ISP.
If connected to your ISP, hang up the connection.
Delete all data currently in the Log. This will make it easier
to read new messages.
Update the data on screen.
28