Table of Contents
Advertisement
For each rule, the following data is shown:
Data
Name - The name you assigned to the rule.
Source - The traffic covered by this rule, defined by the
source IP address. If the IP address is followed by ... this in-
dicates there is range of IP addresses, rather than a single
address.
Destination - The traffic covered by this rule, defined by
destination IP address. If the IP address is followed by ... this
indicates there is range of IP addresses, rather than a single
address.
Action - Action will be "Forward" or "Block"
To add a new rule, click the "Add" button, and complete the
Add
resulting screen. See the following section for more details.
To Edit or modify an existing rule, select it and click the "Edit"
Edit
button.
There are 2 ways to change the order of rules
Move
Use the up and down indicators on the right to move the
selected rule. You must confirm your changes by clicking
"OK". If you change your mind before clicking "OK", click
"Cancel" to reverse your changes.
Click "Move" to directly specify a new location for the se-
lected rule.
To delete an existing rule, select it and click the "Delete" button.
Delete
Clicking the "View Log" button will open a new window and
View Log
display the Firewall log.
Clicking the "System Rules" button will open a new window and
System Rules
display the default firewall rules currently applied by the system.
These rules cannot be edited, but any rules you create will take
precedence over the default rules.
53
Security Configuration
Advertisement
Table of Contents
