System Memory; Supported System Bus Frequency And Memory Speed Combinations - Intel D865PCD Technical Product Specification

Intel Desktop Board D865PCD Technical Product Specification

1.5 System Memory

The board has two DIMM sockets and supports the following memory features:
•
2.5 V (only) 184-pin DDR SDRAM DIMMs with gold-plated contacts
•
Unbuffered, single-sided or double-sided DIMMs with the following restriction:
 Double-sided DIMMS with x16 organization are not supported.
•
2 GB maximum total system memory
•
Minimum total system memory: 64 MB
•
Non-ECC DIMMs
•
Serial Presence Detect
•
DDR333 and DDR266 SDRAM DIMMs
Table 3 lists the supported system bus frequency and memory speed combinations.
Table 3.

Supported System Bus Frequency and Memory Speed Combinations

To use this type of DIMM...
DDR333
DDR266
✏
NOTES
•
Remove the AGP video card before installing or upgrading memory to avoid interference with
the memory retention mechanism.
•
To be fully compliant with all applicable DDR SDRAM memory specifications, the board
should be populated with DIMMs that support the Serial Presence Detect (SPD) data
structure. This allows the BIOS to read the SPD data and program the chipset to accurately
configure memory settings for optimum performance. If non-SPD memory is installed, the
BIOS will attempt to correctly configure the memory settings, but performance and reliability
may be impacted or the DIMMs may not function under the determined frequency.
For information about
Obtaining DDR SDRAM specifications
20
The processor's system bus frequency must be...
533 MHz
533 or 400 MHz
Refer to
Section 1.3, page 16