Intel D865PCD Technical Product Specification page 34

Intel Desktop Board D865PCD Technical Product Specification
For information about
The location of the power connector
The signal names of the power connector
The BIOS Setup program's Boot menu
The ATX12V, SFX12V, and TFX12V specifications
1.11.2.2 LAN Wake Capabilities
CAUTION
For LAN wake capabilities, the +5 V standby line for the power supply must be capable of
providing adequate +5 V standby current. Failure to provide adequate standby current when
implementing LAN wake capabilities can damage the power supply.
LAN wake capabilities enable remote wake-up of the computer through a network. The LAN
subsystem PCI bus network adapter monitors network traffic at the Media Independent Interface.
Upon detecting a Magic Packet* frame, the LAN subsystem asserts a wake-up signal that powers
up the computer. Depending on the LAN implementation, the Desktop Board D865PCD support
LAN wake capabilities with ACPI in the following ways:
•
The PCI bus PME# signal for PCI 2.2 compliant LAN designs
•
The onboard LAN subsystem
1.11.2.3 Instantly Available PC Technology
CAUTION
For Instantly Available PC technology, the +5 V standby line for the power supply must be
capable of providing adequate +5 V standby current. Failure to provide adequate standby current
when implementing Instantly Available PC technology can damage the power supply.
Instantly Available PC technology enables the Desktop Board D865PCD to enter the ACPI S3
(Suspend-to-RAM) sleep-state. While in the S3 sleep-state, the computer will appear to be off (the
power supply is off, and the front panel LED is amber if dual colored, or off if single colored.)
When signaled by a wake-up device or event, the system quickly returns to its last known wake
state. Table 9 on page 32 lists the devices and events that can wake the computer from the
S3 state.
The Desktop Board D865PCD supports the PCI Bus Power Management Interface Specification.
For information on the version of this specification, see Section 1.3. Add-in boards that also
support this specification can participate in power management and can be used to wake the
computer.
The use of Instantly Available PC technology requires operating system support and PCI 2.2
compliant add-in cards and drivers.
34
Refer to
Figure 9, page 46
Table 21, page 49
Table 57, page 96
Section 1.3, page 16