Programming Recordings With The Guide Plus+ System - Philips DVDR80 Operating Instructions Manual

88
Programming recordings with the GUIDE
Plus+ ® System
The GUIDE Plus+ ® System has made it even easier to programme recordings. All you have to do
is select the show you want to record from a channel listing.
1
Switch on the TV set. If required, select the programme number for
the DVD recorder.
2
Press GUIDE/TV on the remote control.
3
Use P+ A or P- B to select the TV station, and D or C to select
the show to record.
a I do not see all available TV channels
b Please check your correct channel line up in the 'Editor' screen.
Read therefore the section 'The 'Editor' screen in the chapter 'The GUIDE
®
Plus+ system.
b The GUIDE Plus+
®
were detected by the GUIDE Plus+
TV channels that do not have this 'channel identification' are not available in
®
the GUIDE Plus+
Please use 'Manual TIMER programming' to program TV shows of such TV
channels.
4
Confirm using the red function button of the remote control
('Record' on the screen).
You can also use
RECORD on the DVD recorder.
The TV show is programmed for recording.
Read the information on the screen.
a 'Warning, this programme number has not been allocated, please
go to Editor to set it.' appears on the screen
b The programme number of the TV channel is not available in the GUIDE
®
Plus+ system or allocation is wrong.
To change or check the channel data, proceed as follows:
1 Press P+ A .
2
Select 'Editor' with C .
3
Select the TV channel using P- B or P+ A .
4
Press C to go to the right tile.
In case you can receive the selected channel only via an external
receiver, press the red button to select the corresponding source.
5
Press the green button.
6
Enter the programme number of the TV channel using the number
buttons.
If the source you have selected is an external receiver, enter the
programme number that you would also enter at the external receiver
for this TV channel.
'Grid' screen contains only those TV channels that
®
system using a 'channel identification'.
system.
REC/OTR n on the remote control or
Programming a recording (TIMER)
Problem
Problem