Table of Contents
Advertisement
01DVDR980UMUKGB24271F3
21-01-2002
l Adjust the recording level with MANUAL 3 or 4
on the DVD recorder, so that the '0 dB' mark lights
up during the loudest parts of the recording.
l You can switch back to automatic audio level control
by pressing AUTO/MAN REC VOLUME again.
‰ The display will show the current disc position
and
disappears.
MANUAL
Recording with automatic switch-off (OTR
One-Touch Recording)
CLEAR
SELECT
TIMER
VOL
MUTE
T/C
l Insert a recordable DVD+RW or DVD+R disc.
l Use CHANNEL 3 or CHANNEL 4 (on the
recorder) or CH+, CH- (on the remote control) to
select the programme number (programme name)
from which you wish to record.
l Press RECORD (on the recorder) or REC/OTR
(on the remote control) twice.
‰ A recording will be made of 30 minutes.
‰ The required end time of the recording is shown
in the timer box on screen. The remaining recording
time is shown on the display.
l Press RECORD or REC/OTR again to obtain a
30 minute increment.
l Shortly after pressing REC/OTR, OTR can be
cancelled by pressing CLEAR.
Timer programming
The DVD recorder needs the following information for
every programmed recording:
- the date on which the recording is to be made;
- the channel;
- the start and stop time of the recording;
- VPS/PDC on or off;
- the recording mode (HQ, SP, LP or EP).
The DVD recorder stores all the information mentioned
above in a timer block. You can programme up to six
timer blocks, one month in advance.
30 RECORDING
15:24
Pagina 30
CH
MONITOR
ON/OFF
REC/OTR
PREVIOUS
NEXT
REVERSE
PAUSE
SLOW
FORWARD
STOP
FSS
PLAY
A/CH
10: 15hr
When you have programmed the timer, a red line on
the disc bar (both on the display and on the Index
Picture Screen) indicates what part of the disc will be
overwritten by the programmed recording from the
current disc position (on DVD+RW) or after the last
title (on DVD+R).
When all timer blocks are full, the options timer
programming and VIDEO Plus+ programming cannot be
accessed. For clearing a timer block, see 'How to clear a
timer block'.
What is 'VPS'/'PDC'?
With 'VPS/PDC', the TV station controls the
beginning and the length of the programmed
recording. This means that the video recorder
switches itself on and off at the right time even if a
TV programme you have programmed begins earlier
or finishes later than expected.
Usually the start time is the same as the VPS/PDC
time. If, however, in the TV guide, in addition to a TV
programmes start time, a different VPS/PDC time is
given, e.g.: '20.15 (VPS 20.14)', you must enter '20.14'
as the start time exactly to the minute. If you want
to enter a time that differs from the VPS/PDC time,
you must switch off 'VPS/PDC'.
Timer programming with the VIDEO
Plus+
®
system
CLEAR
TIMER
A PlusCode number is a number of up to nine digits,
printed in most TV guides next to the start time of a TV
programme.
All the information required for a programming is
contained encoded in the PlusCode programming number.
l Select 'VIDEO Plus+ programming' with v (up
cursor) or w (down cursor).
T i m e r
V I D E O P l u s
p r o g r a m m i n g
+
T i m e r p r o g r a m m i n g
T i m e r l i s t
T o e x i t
P r e s s T I M E R
l Press u (right cursor).
SELECT
Advertisement
Table of Contents
