Table of Contents
Advertisement
General
Use 'Programming a recording (TIMER)', to automatically start and stop
a recording at a later date.
The DVD recorder will switch to the right programme number and
begin recording at the correct time.
On this DVD recorder you can pre-programme up to 12 recordings
within a period of one month.
To make a programmed recording, your DVD recorder needs to
know:
* the date you want to make the recording
* the programme number of the TV channel
* the start and stop time of the recording
This information is saved in a 'TIMER block'.
Before you begin, make sure the clock is set. If the clock is not set, the
'Time/Date' menu will appear when you press the TIMER s button.
Programming a recording (TIMER)
Programming recordings with the
®
G Code
System
Thanks to this programming system, you no longer need to tediously
enter the date, programme number, start and finish times. All the
information needed by the DVD recorder for programming is
contained in the G-Code
number is found in most TV listings magazine.
1 Switch on the TV set. If required, select the programme number
for the DVD recorder.
2 Press TIMER s on the remote control.
P
The 'Schedule' screen will appear
3 Press the red function button ('G-Code').
4 Enter the entire G-Code number. This number is up to 9 digits
long and can be found next to the start time of the TV programme
in your TV listings magazine.
e.g.: 5-312-4 or 5,312 4
Enter 53124 for the G-Code-number.
Use therefore the number buttons 0..9 on the remote control.
If you make a mistake you can press D or the green action button
to go back a position.
5 Confirm with OK .
®
programming number. This 9-digit G-Code
Manual
Home
G-Code
Please enter the G-Code programming number and
press OK to confirm.
= = = = = = = = =
Grid
Search
Schedule
Info
No programmes
®
Once 0
33
Advertisement
Table of Contents
