Philips DVDR80 Operating Instructions Manual page 100

Manual
VIDEO Plus+
Please enter the PlusCode programming number and
press OK to confirm.
= = = = = = = = =
Grid Search Schedule
No programmes
VIDEO Plus+ Manual
Please enter the PlusCode programming number and
press OK to confirm.
1 2 3 4 5 = = = =
Grid Search Schedule
Watch/Record
21-Oct 20:00 21:30 BBC1
90
4
Enter the entire PlusCode number. This number is up to 9 digits long
Home
and can be found next to the start time of the TV programme in your
TV listings magazine.
Info e.g.: 5-234-89 or 5 234 89
Enter 523489 for the PlusCode number.
M2 Once 0
Use therefore the number buttons 0..9 on the remote control.
If you make a mistake you can press D or the green action button to
go back a position.
5
Confirm with OK .
a 'VIDEO Plus+ system' appears on the screen
b This message appears when the TV channel has not been assigned in the
GUIDE Plus+
To change channel data, proceed as follows:
1 Press P+ A .
2
Select 'Editor' with C .
3
Select the TV channel using P- B or P+ A .
4
Press C to go to the right tile.
In case you can receive the selected channel only via an external
receiver, press the red button to select the corresponding source.
5
Press the green button.
6
Enter the programme number of the TV channel using the number
buttons.
If the source you have selected is an external receiver, enter the
programme number that you would also enter at the external receiver
for this TV channel.
7
Confirm with OK .
a The following message appears on the screen: 'PlusCode number
wrong'
b The entered PlusCode number is incorrect. Repeat the entry or end with
TIMER s .
b Check time/date (see chapter 'Installing your DVD recorder', section
'Setting the time & date').
6
The decoded data appears after confirmation.
Home
You can use the colour buttons to make the following settings. First,
the right tile must be highlighted ( C button). Check the functions
Info (descriptions) in the corresponding colour field before pressing a
Qual. Freq. Timing
button.
M2 Once 0
Extending end time
Enter the minutes you want the recording to last longer using the yellow
button.
Activate 'VPS/PDC'
Keep pressing the yellow action button until 'VPS/PDC' appears instead of the
time.
Setting up repeat recordings
You can choose from the following settings with the green action button:
'Frequency':'Once': single recordings
Entering the recording quality
You can choose from the following settings in the right tile using the red
action button: 'M1, M2, M2x, M3, M4, M6, M8'.
®
system yet.
'M-F': Repeated daily recordings (Monday to Friday).
'Mon': Repeated weekly recordings (every week on the same day
e.g. Monday).
Programming a recording (TIMER)
Problem
Tip