Connecting With A Scart Cable And 'Easy Link - Philips DVDR80 Operating Instructions Manual

Connecting the DVD recorder
Connecting with a scart cable and 'Easy
Link'
Your DVD recorder can exchange information with your TV set using 'Easy Link'. Your TV
channels can also be transferred in the same order from your TV set to your DVD recorder
using 'Easy Link'.
Please see your TV's operating instructions.
Have the following cables ready:
an aerial cable (1, supplied), a mains cable (2, supplied), a special scart cable (3, suitable for
Easylink).
1
Switch off your TV set.
2
Remove the aerial cable plug from your TV set. Insert it into the
ANTENNA IN socket at the back of the DVD recorder.
3
Insert one end of the supplied aerial cable into the TV OUT socket at
the back of the DVD recorder and the other end into the aerial input
socket at the back of the TV set.
4
Plug in a full-pin scart cable (all 21 contacts wired) into the scart
socket EXT 1 TO TV-I/O at the back of the DVD recorder and the
corresponding scart socket - suitable for Easylink - at the back of the
TV set (see TV set operating instructions).
5
Read the next chapter 'Connecting additional devices' on how to
connect additional devices (satellite receivers, videorecorders,...) to the
input-/output sockets.
6
Switch on the TV set.
7
Use the supplied mains cable to connect the mains socket
4MAINS at the back of the DVD recorder with the wall outlet.
The most important features of the DVD recorder will appear in
scrolling text on the display. After the first installation is completed
this function will be switched off. How you switch on this function
again, read in the chapter 'User preferences' in the section 'standby'.
13