Speaker Settings - Integra DTR-5.9 Instruction Manual

First Time Setup—Continued

Speaker Settings

If you change these settings, you must run the auto-
matic speaker setup again (see page 39).
Enter
Setup
If the impedance of any speaker is 4 ohms or more but
less than 6, set the Speaker Impedance to 4 ohms.
North American models do not support speakers
with an impedance of less than 6 ohms.
To use bi-amping, you must change the Speaker Type
setting. For hookup information, see page 18.
Notes:
• When bi-amping is used, the AV receiver is able to
drive up to 5.1 speakers in the main room.
• Before you change these settings, turn down the vol-
ume.
The onscreen setup menus appear only on a TV that is
connected to the HDMI OUT. If your TV is connected
to the composite video or S-Video MONITOR OUT,
or the COMPONENT VIDEO OUT, use the DTR-
5.9's display when changing settings.
1
Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
If the main menu doesn't appear, make
sure the appropriate external input is
selected on your TV.
2
Receiver
3
4
5
6
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
Use the Up and Down [
buttons to select "2. Speaker
Setup," and then press [Enter].
Use the Up and Down [
buttons to select "1. Speaker Set-
tings," and then press [Enter].
Use the Up and Down [
buttons to select "Speaker
Impedance," and use the Left and
Right [ ]/[ ] buttons to select:
4 ohms: Select if the impedance of any
speaker is 4 ohms or more but
less than 6.
6 ohms: Select if the impedances of all
speakers are between 6 and
16 ohms.
Use the Up and Down [
buttons to select "Speaker Type,"
and use the Left and Right
[ ]/[ ] buttons to select:
Normal: Select this if you've con-
nected your front speakers
normally.
Bi-Amp:Select this if you've con-
nected your front speakers for
bi-amped operation.
Press the [Setup] button.
Setup closes.
]/[ ]
]/[ ]
]/[ ]
]/[ ]
43