Common Functions; Setting The Display Brightness; Muting The Av Receiver; Using The Sleep Timer - Integra DTR-5.9 Instruction Manual

Common Functions

This section explains functions that can be used with any
input source.
Press
[Receiver]
first
Dimmer
Phones Dimmer

Setting the Display Brightness

You can adjust the brightness of the display.
Remote Press the [Receiver] Remote
controller
Mode button, and then press the
remote controller's [Dimmer] but-
ton repeatedly to select: dim,
dimmer, or normal brightness.
You can also use the AV receiver's
[Dimmer] button (not European mod-
els).
AV receiver
Display
Muting
Sleep
Display

Muting the AV Receiver

You can temporarily mute the output of the AV receiver.
Press the [Receiver] Remote
Mode button, and then press the
remote controller's [Muting] but-
ton.
The output is muted and the MUTING
indicator flashes on the display.
To unmute the AV receiver, press the remote control-
ler's [Muting] button again, or adjust the volume. The
output is unmuted and the MUTING indicator goes off.
Muting is cancelled when the AV receiver is set to
Standby.

Using the Sleep Timer

With the sleep timer, you can set the AV receiver so that
it turns off automatically after a specified period.
Press the [Receiver] Remote
Mode button, and then press the
remote controller's [Sleep] but-
ton repeatedly to select the
required sleep time.
You can set the sleep time from 90 to 10
minutes in 10 minute steps.
The SLEEP indicator appears on the
display when the sleep timer has been
set, as shown. The specified sleep time
appears on the display for about 5 sec-
onds, then the previous display reap-
pears.
SLEEP indicator
To cancel the sleep timer, press the [Sleep] button
repeatedly until the SLEEP indicator disappears.
To check the remaining sleep time, press the [Sleep]
button. Note that if you press the [Sleep] button while the
sleep time is being displayed, you'll shorten the sleep
time by 10 minutes.
49