Listening To Radio Broadcasts; Tuning Into A Radio Station; Listening To A Stereo Radio Station (Fm Mode) - Integra DTR-5.3 Instruction Manual

Listening to Radio Broadcasts

One of the features of the DTR-6.3/5.3 that is most frequently used is
its ability to play FM and AM broadcast radio stations. The DTR-
6.3/5.3 provides a number of listening modes perfect for listening to
the radio and getting the most out of your audio system. Also, by
presetting radio stations that you listen to frequently, you can select
them easily by pressing the CH

Tuning into a radio station

1. Press the Tuner input source button.
Each time you press the Tuner button, the
input source changes between AM and FM.
2. Using the Tuning and
the front panel, tune into the station
you desire.
"FM STEREO"
(Lights red)
Band Frequency
• The tuner frequency changes in 50-kHz increments for FM
and 10-kHz increments for AM.
• You can press the Tuning
more than 0.5 seconds to scan for an FM station in the
direction of the button you pressed (FM auto tuning mode).
After you release the button and a station is received in stereo,
the scanning stops.
button on the remote controller.
buttons on
Tuned
in stereo Auto mode
TUNED
FM STEREO AUTO
or button continuously for
Tuning /
FM Mode
Tuner

Listening to a stereo radio station (FM mode)

When you tune into a radio station,
indicator appears in the display. If you tune into
an FM station in stereo, then "FM STEREO"
appears. If the signal is weak, it may be
impossible to tune into the station in stereo. In
such a case, press the FM Mode button on the
front panel. The AUTO indication disappears
and the radio station is output in the monaural
mode. To return to stereo, press the FM Mode
button again. "AUTO" appears. Some inter-
station noise may be heard, but the sound will
not cut in and out as it would if stereo was
selected.
TUNED
41