Connecting Your Video Components - Integra DTR-5.3 Instruction Manual

Connections (DTR-5.3)
Connecting a DVD Player with 5.1-Channel Output
: Signal flow

Connecting your video components

Below is an example of how you can connect your video components
to the DTR-5.3. Refer to the diagram above for the following
connection examples.
COMPONENT VIDEO INPUT/OUTPUT
For DVD players or other devices that have component video
connectors, the DTR-5.3 has two banks of component video input
connectors (Y, P , P ) for direct component video input. The DTR-
B R
5.3 also has one bank of component video output connectors for
direct component video output to the matrix decoder of a television,
projector, or other display device. By sending the pure component
video signal directly, the signal forgoes the extra processing that
normally would degrade the image. The result is vastly increased
image quality, with incredibly lifelike colors and crisp detail.
• The signal that comes in from COMPONENT VIDEO INPUT is
only sent to COMPONENT VIDEO OUTPUT. When
connecting a video player to the COMPONENT VIDEO INPUT
jacks, be sure to connect your television to the COMPONENT
VIDEO OUTPUT jacks.
VIDEO IN/OUT
These are the video inputs and outputs. On the rear panel, there are
four video inputs and one video output and each one includes both
composite video and S video configurations.
Connect VCRs, VTRs, LD players, DVD players, and other video
components to the video inputs. Connect VCRs, VTRs, and other
recording components to the video outputs to make video
recordings.
• When connecting a VCR or other video component, make sure
you connect its audio and video leads to the same bank (e.g.,
both to VIDEO 3).
• The Video 4 inputs are located on the front panel.
24
FM 75 AM
ANTENNA
12 V
TRIGGER
IR OUT
OUT LINE IN
56K 40K ZONE 2 DC IN
OUT 24V 1A
A
A
L
B
B R
REMOTE
CONTROL
VIDEO 3 VIDEO 2
DIGITAL DIGITAL
IN IN
DIGITAL INPUT OUTPUT INPUT
OPTICAL OPTICAL COAXIAL
V
2 1
S
CD TAPE
IN OUT IN IN IN
L L
SUBWOOFER
PRE OUT
R R
VIDEO 3 VIDEO 2
COMPONENT VIDEO
INPUT 2 INPUT 1 OUTPUT
RS232
Y
P
B
P
R
VIDEO 1 DVD MONITOR I R
OUT
OUT IN IN
OUT
V
IN
S
OUT IN FRONT SURR CENTER
L
R
SUB
VIDEO 1
WOOFER
DVD
The flow of the video signals is as follows:
The signal that comes in from a VIDEO IN jack is sent to both the
VIDEO OUT and S VIDEO OUT jacks. The signal that comes in
from a S VIDEO IN jack is sent to both the S VIDEO OUT and
VIDEO OUT jacks. It is not necessary to make both video and S
video connections.
Notes:
• If your video output device (e.g., television or projector) is
connected only to the MONITOR OUT VIDEO jack,
MONITOR OUT S VIDEO jack, or both, and the video signal
from the source component is input through the component
video connectors, no picture will appear. Video sources input
from the component video connectors can only be output from
the component video connectors.
• For more information about the DIGITAL INPUT/OUTPUT
jacks, see page 24.
Y
P
Component video output
B
P
R
Video ouput
S video output
3. DVD player (DVD)
Analog audio output
(center)
Analog audio output
(subwoofer)
L (white)
Analog audio output
(surround L/R)
R (red)
L (white)
Analog audio output
(front L/R)
R (red)
Digital audio output
(coaxial)