Entering A Pre-Programming Code; Learning A Pre-Programming Code - Integra DTR-5.3 Instruction Manual

Entering a pre-programming code

The remote controller has three learning functions. One is entering
the pre-programmed code for a remote controller of another
manufacturer. Another is the normal learning function that enables
the remote controller to learn the codes directly from other remote
controllers (see page 69). And the last is a macro learning function
that enables you to program a series of operations into the remote
controller so that the operations can all be performed at once by
pressing one button (see page 72).
Display
Caution:
With some brand's components, some buttons may not work
correctly. In this case, program the command directly from the other
remote controller normally (see page 69).
66

Learning a pre-programming code

By entering a pre-programming code, you can have the RC-481M
remote controller operate a component made by another
manufacturer. The buttons that are used for operation are given on
the next page.
1. Find the 3-digit number listed for the manufacturer
2. Turn on the component that you want to operate (i.e.
Send/Learn
indicator
3. While holding down the Mode button on the RC-481M
Buttons that
can be pre-
programmed
VOL
4. Within 30 seconds, enter the 3-digit code number.
5. Press the button that you programmed and check if
Numeric keys
When entering the code of Integra/Onkyo DVD players:
There are three SETTING numbers. Choose the SETTING number
according to how you will be using the DVD player.
No. 601/613: These codes are for operating the Integra/Onkyo DVD
player by pointing the remote controller directly at it, either because
it does not have an
it with an
properly, enter 613.
No. 600: This code is for Integra/Onkyo DVD players that have an
cable. You will then operate the DVD player by pointing the remote
controller at the remote control sensor on the DTR-6.3/5.3. You do
not need to enter this code because it is factory preset. However, if
the code has been changed to 601 or 613, then you will need to
change it back to 600.
name of the component that you want to operate in the
table on the next page.
DVD, satellite tuner, or television).
that you want to program, press the Display button,
and then release both buttons.
The Send/Learn indicator lights when the Mode button is
pressed and turns off when the Display button is pressed. When
the indicator turns off, release both buttons. The Send/Learn
indicator lights again.
The Send/Learn indicator slowly flashes twice. If the Send/
Learn indicator quickly flashes three times, then either a
mistaken 3-digit code was entered or an incorrect operation was
performed. If this occurs, return to step 3.
the system operates correctly.
• If the component does not operate properly, return to step 3
and repeat the steps above.
• If it still does not operate properly, program the command
directly from the other remote controller normally (see page
69).
terminal, or it does but you are not connecting
cable. First enter 601 and if it does not operate
terminal that you are connecting to the DTR-6.3/5.3 with an