Controlling External Output Terminal - Panasonic BB-HCM311 Operating Instructions Manual

2.28 Controlling External Output Terminal

The digital output terminal allows you to control external devices. You can change
the initial status of the output signal.
Note
Connect the external devices to the camera.
1.
Click [External Output] on the Setup page.
2.
Click [Save] when finished.
• Clicking [Cancel] cancels your settings without saving changes.
• New settings are saved.
• When finished, "Success!" is displayed.
Setting
External Device
Control Output
Button name
modification
3.
Click [Go to External Output Control page].
• The External Output Control page is displayed.
• If you check [Open], the internal transistor turns off and the
external output terminal gets high impedance (open
collector) when the camera powers up. If you check [Short
to GND], the internal transistor turns on and is electrically
short-circuited to GND pin when the camera powers up.
The external output terminal gets low impedance (0 V).
• You can change the output control button names on the
operation bar. You can name the button depending on your
external devices.
Description
Operating Instructions
143