TurboChef i3 Service Manual page 86

A-10 APPENDIX - REPLACING OVEN COMPONENTS
Removing Right Side Cover Required (Figure A-9)
CAUTION: Before removing/installing any component, make sure it is disconnected from the
wire harness (where applicable).
CAUTION: Be careful to not tear the insulation when servicing components. Always reset the
insulation properly before reinstalling the side panel.
Hardware listed is required for installing component to oven.
To remove the right side cover:
1. Remove the screws securing the panel to the oven frame.
2. Remove the right side cover.
Figure A-9: Removing Right Side Cover Required
Figure
Item Description
Reference #
1 Catalytic Converter
N/A Cover, Right Side
2 Heater Assembly
3 Helper Spring, Interlock Switch*
4 Interlock Switch - Monitor*
5 Interlock Switch - Secondary*
6 Mounting Bracket, Interlock Switch*
N/A RTD, Cook Cavity
7 Shield, Heater Insulation (x2)
8 Thermostat, High-Limit
* NOTE: For more interlock switch detail, see Figure A-10, page A-11.
1
8
3 4 5 6
Item Part Number Hardware Description
i3-9066 None
i3-9302 Screw, #8, Serr PPHD, Truss, Black Oxide 101691 (qty 5)
i3-9380 Screw, Sh Mtl #8 x 1/2, Serrated PHTRH
i5-9397 None
102012 Screw, #4-40 x 1", PPH, Sems
102012 Screw, #4-40 x 1", PPH, Sems
i5-9272 Screw, #10-32 x 3/4 lg, PPH Sems, Int Th 102937 (qty 2)
HHC-6517-2 Screw, Sh Mtl #8 x 1/2, Serrated PHTRH
i5-9216 None
102075 Screw, M4 x 6, PPH SQ CO Sems, Zinc
7
2
Hardware Part Number(s)
None
101688 (qty 10)
None
102903 (qty 2)
102903 (qty 2)
101688 (qty 2)
None
101672 (qty 2)