TurboChef i3 Service Manual page 64

42 TROUBLESHOOTING
Is the high-limit
thermostat tripped?
YES
Reset (page 32) and
determine why it
tripped – excess
grease buildup, etc.
Are both blower motors moving air?
YES
Check in
Is the heater defective? Check in
NO
TEST MODE
Replace defective
heater and solid state
relay.
F9: CC TEMP (Cook Cavity Temperature High)
If this fault frequently occurs,
- Ensure the oven is cleaned daily (see pages 7-8).
- Determine if large amounts of grease-laden food are being cooked, and if
so, recommend smaller portions per cook cycle.
Troubleshooting:
F8: HEAT LOW
- see page 16.
TEST MODE
- see page 16.
YES NO
Is the solid state relay
defective or damaged?
YES
Replace the solid
state relay.
Troubleshooting:
NO
See page 37
to troubleshoot
F1: BLOWER
(Blower Running
Status Bad)
NO
Is the wiring from the solid
state relay to the control
board OK? (See page 49 for
schematic.)
NO
YES
Replace the
Correct wiring.
control board.