GE Profile PB975 Technical Service Manual page 43

Method #2:
1. Disconnect power from the range.
2. Remove the range from the installation.
3. Remove the rear panel. (See
4. Disconnect the right side upper oven light
assembly wire harness.
5. Remove the two ¼-in. hex-head screws that
attach the light housing to the oven liner.
Right Side Upper Oven Light
6. Carefully pull the light assembly and wire
harness from the oven liner.
Note:
• Upon reassembly, ensure displaced insulation
around the wiring entry hole is returned to its
original position.
• There is a gasket placed between the light
assembly and the oven cavity. Be sure to install
the gasket to its original location.
.)
Rear Cover Removal
– 43 –
Oven Light Bulbs
Caution: Before replacing your oven light bulb,
disconnect the electrical power to the range at the
main fuse or circuit breaker panel.
Note: The glass cover should be removed only when
cold. Wearing latex gloves may offer a better grip.
To remove a light bulb:
Turn the glass cover counterclockwise 1/4 turn until
the tabs of the glass cover clear the grooves of the
socket.
Receptacle
Glass cover
Using gloves or a dry cloth, remove the bulb by
pulling it straight out.
Receptacle
Socket
Bulb
Tab
Use gloves
or cloth
(Continued next page)