GE Profile PB975 Technical Service Manual page 35

To replace the upper oven door:
1. Pull the hinges down away from the oven frame
to the fully open position.
2. Lift up on the hinge locks and rotate toward the
oven frame until they stop.
3. The hinges will release to the 45-degree position.
The hinge locks will contact the oven frame.
4. Slide the door back onto the hinges. Make sure
the buttons pop back out.
5. Fully open the door.
6. Rotate the hinge locks back toward the door
and onto the hinge.
7. Close the oven door.
To remove the outer door assembly:
1. Remove the door. (See
.)
Assembly
2. Place the door assembly gasket side down on a
protective surface.
3. Remove the 4 Phillips-head screws that attach
the bottom of the outer door assembly to the
outer door.
4. Remove the Phillips-head screw from each side
of the outer door panel.
5. Separate the outer door assembly from the
inner door.
6. Place the outer door assembly handle side
down on a protective surface.
Upper Oven Door
7. Remove the six ¼-In. hex-head screws that
attach the handle to the outer door assembly.
8. Remove four ¼-in. hex-head screws from each
side of the outer door panel.
9. Slide the outer door glass down to clear the 6
retaining tabs.
– 35 –
Tabs
(Continued next page)